[rockfordua]

ATF 9 литров надо, уровень переливом при температуре ATF 40 градусов серектор на паркинге, мотор на холостых

Checking and topping up the ATF
The transmission must not be in the reduced driving program. The ATF temperature must be between → ATF temperature: 30 degrees Celsius and → ATF temperature: 40 degrees Celsius . An ATF inspection when the temperature is too high causes insufficient filling, while an inspection when the temperature is too low causes over-filling. The selector lever must be in position "P" and the engine must be idling. The air conditioning must be switched off. The vehicle must stand horizontally. Note

The ATF temperature at the start of testing must not be higher than → ATF temperature: 40 gradCelsius .

1. Connect the PIWIS Tester 97180 and call up the ATF temperature.
2. Put selector lever in position "P", start vehicle, and allow engine to idle.
3. Top up ATF via the charging valve until ATF runs out at the control bore.
4. With the brake pedal pressed, change through all selector lever positions, remaining in each position for approximately → Time: 10 s .

5. Top up with ATF again via the charging valve until ATF runs out at the control bore.